True Street Cars Forums banner
Cancel

Can it be! the busa slowly is being reborn

Jump to Latest Follow
1 - 19 of 19 Posts
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #1 ·
So after a month of bitching at my builder i went to the shop and my engine which had become a perminat fixture on the floor had been moved.
i looked for my head and it was gone from the bucket from which it has sat for 5 months!!! after a little hunting i found it. and progress was made. my builder ported and polished the intake and exhaust, welded small studs on the intake side. tapped and threaded them, my wet shot nos nozzels were in each intake. my new valves were in with the super bad ass springs and titanium retainers.
today i ordered my super long chain to fit on my extended swing arm.
here are some of the mods i have
super bad ass clutch basket. dont want that going boom (mrabq)
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=4703060&showprevnext=1
retainers
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=306002&showprevnext=1
new output shaft $364
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=4877082&showprevnext=1
stiff ass springs $130
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=306059&showprevnext=1
studs $160
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=1120363&showprevnext=1
mickey tompson drag tire $233
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=2930807&showprevnext=1
cams 395
http://www.hayabusazone.com/cams.html
falicon rods $1000
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=306003&showprevnext=1
ape ultra light and perfectly balanced crank $255
http://www.hayabusazone.com/crank.html

still have to buy the delux version of this
http://www.schnitzracingstore.com/catalogs/catalog.asp?prodid=2345845&showprevnext=1
 
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #7 ·
i went to put on my extende swing arm tonight but i broke my tool.. damit any who should be on tomorrow.
oh yeah i got the 14 back
 
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #11 ·
motor is not new but they replaced every seal and gasket pistons up. and it is still doing what it did when i took it in,. i am pretty sure the pc is just dumping too much fuel in the motor, i am gonna tae the bike to rich to reprogram the pc.
ill have some busa pics soon
 
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #13 ·
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #15 ·
G

·
#16 · (Edited)
J

·
Registered
Joined
·
3,748 Posts
Discussion Starter · #18 ·
well ed said it should be back to gether by this weekend. i plan to see that he gets a fair amount done
 
1 - 19 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
18 Replies
9 Participants
Last post:
TRMIN8R
True Street Cars Forums
A forum community dedicated to street car owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Automotive
Top